Automating The Change To Standard Mode - Avaya IP500 V2 Installation Manual

4.12.2 Automating the Change to Standard Mode

If the only systems that you install are ones using IP Office standard modes, IP Office Manager can be set to automatically
default the system to IP Office standard mode.
!
WARNING
·
This process requires the IP Office system to reboot in order to complete the changes. The reboot ends any current
calls and services.
1. In IP Office Manager, select File | Preferences.
2. On the Preferences sub-tab, enable Default to Standard Mode.
3. With this option enabled, when a configuration for a new or defaulted system running in IP Office Basic Edition is
received by IP Office Manager, it will automatically be converted to a IP Office Essential Edition configuration.
!
4. Important: IP Address Settings Default to Server
The conversion will set the DHCP mode to Server and the LAN addresses to their defaults of 192.168.42.1 and
192.168.43.1. Using IP Office Manager to change these settings to the required values.
5. This is a suitable time to begin
to restart in IP Office Essential Edition.
· For IP Office Release 8.0 and higher, for an IP500 V2 system to run in IP Office Essential Edition, IP Office
Preferred Edition or IP Office Advanced Edition mode, its configuration must include an Essential Edition
license. A system without this license will not allow any telephony functions until the license is added.
6. Sending the configuration back to the system restarts the system in IP Office Essential Edition mode.
Installing IP500/IP500 V2
IP Office 9.0
initial configuration before sending the configuration back to the IP Office system
102
15-601042 Issue 28c (19 August 2013)
Page 98