7. Sd Card Management - Avaya IP500 V2 Installation Manual

7. SD Card Management

This chapter is currently set for standard mode only as it covers the thick clients.
The IP500 V2 control unit has two SD card slots, labeled System SD and Optional SD respectively. These are used as
follows:
· System SD Card
An Avaya System SD card must be present in this slot at all times. This card holds copies of the IP Office firmware
and configuration and is used as the IP500 V2 control units non-volatile memory.
· Each Avaya System SD card has a unique Feature Key serial number which is used for generating and
validating licenses entered into the IP Office configuration.
· The card stores the prompts for Embedded Voicemail operation and acts as the message store for Embedded
Voicemail messages.
· Prior to any planned shutdown or restart of the IP Office system, the current configuration running in the IP
Office system's RAM memory is copied to the /primary folder on the System SD card and to the systems non-
volatile memory.
· Following a restart, the software in the /primary folder is loaded by the IP500 V2 control unit. If the required
software is not present or valid a sequence of fallback options is used, see
full details.
· Following a restart, if present, the configuration file in the /primary folder is loaded by the IP500 V2 control
unit. If no file is present the system will check for a file in its internal non-volatile memory. If no copy is found
it will generate a default configuration file. See
· Once each day (approximately between 00:00 and 00:30) the IP Office will copy the current configuration
running in its RAM memory to the /primary folder on the card.
· Configuration changes made using IP Office Manager are first written to the copy of the configuration file on
the card and then merged with the configuration running in the IP Office system's RAM memory.
· The write lock setting on cards in the System SD card slot is ignored.
· Optional SD Card
A card does not have to be present in this slot for normal IP Office operation. The slot can be used for various
maintenance actions.
· A card with an updated IP Office software or configuration can be inserted and those files then transferred to
the System SD card in order to upgrade the IP Office system.
· The full contents of the System SD card can be copied to the Optional SD card while the IP Office system is
running.
· The write lock setting on cards in the Optional SD card slot is honored.
Memory cards should always be
Card
Though the card slot LEDs indicate when data is being written to an card, lack of flashing LED is not a
Removal
sufficient safeguard. Shutting down the card disables Embedded Voicemail and IP Office Web Manager. If
the System SD card is removed, features licensed by the card's serial number continue operating for up
to 2 hours.
Card Specification
Non-Avaya cards can be used in the Optional SD slot as long as they match or exceed the standard below:
· SDHC 4GB minimum Class 2+. Single partition FAT32 format.
Installing IP500/IP500 V2
IP Office 9.0
Booting from the SD Cards
shutdown before being removed when the system is running.
140
Booting from the SD Cards
for full details.
124
15-601042 Issue 28c (19 August 2013)
for
124
Page 122