Checking The Leds - Avaya IP500 V2 Installation Manual

4.11.1 Checking the LEDs

Control Unit LEDs
LED
Optional SD
System SD
CPU
Base Card LEDs
Base Card
All Cards
IP500 Analog Phone
IP500 Digital Station
IP500 TCM8
IP500 Combination
IP500 VCM
IP500 4-Port Expansion
Trunk Daughter Card LEDs
Trunk Daughter Card
All cards
Analog Trunk
PRI Trunk
BRI Trunk
Installing IP500/IP500 V2
IP Office 9.0
Description
· Off = Card shutdown.
· Green on = Card present.
· Green flashing = Card in use.
· Orange steady = Reset imminent.
· Alternate red/green = Starting up.
· Green on = Okay.
LEDs 1 to 8 Usage
· LED1 is also used for base card status:
· Red On = Error
· Red Slow Flash = Initializing.
· No status LEDs are used for analog phone extensions.
· Green Flashing = Phone detected.
· Green On = Phone active.
· Green On = Phone detected.
· LEDs 1 to 6
· Green Flashing = Phone detected.
· Green On = Phone active.
· LEDs 1 to 8 are unlabelled. They are used to indicate voice compression channel usage.
Each LED lit represents 12.5% of the available voice compression channel capacity in
use (total card capacity rather than licensed capacity).
· LEDs 1 to 8 are used for the expansion ports on the rear of the control unit. LEDs 9 to
12 are used for the card's own expansion ports.
Green On
Red Flashing
Red On
Orange Regular Flash
LEDs 9 to 12 Usage
· LED 9 is also used for daughter card status.
· Red On = Error
· Red Slow Flash = Initializing.
· Green on = V1: Card installed. V2: Line connected to the port but idle.
· Green flashing = Line in use.
· Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
· Red/Green Fast Flash (port 9) or Green Fast Flash (port 10) = Alarm indication
signal (AIS) from the trunk remote end.
· Red with Green Blink (port 9) or Green Blink (port 10) = Port in loopback mode
(set through IP Office System Monitor).
· Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
IP500 V2 Installation: Starting the System
· Red flashing = Card initializing or
shutting down.
· Red fast flashing = card full
· Red steady = Card failure/wrong type.
· Red on = No software.
· Flashing Red = Error/Shutdown.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
Expansion module present.
Initializing.
Error.
Base card okay.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
15-601042 Issue 28c (19 August 2013)
Page 95