Etr6 Card - Avaya IP500 V2 Installation Manual

10.3.7 ETR6 Card

This card is used to add 6 ETR phone extension ports to an IP500 V2 control unit. This card is only supported by IP500 V2
systems running in IP Office Basic Edition - PARTNER® Mode or IP Office Basic Edition (Mu-Law) modes.
It also includes 2 analog extension ports which are for emergency use only when the card is fitted with an analog trunk
daughter card. A further 4 RJ45 ports (9 to 12) are provided for trunk connections when an IP500 trunk daughter card is
fitted to this card.
Port Type Ports
ETR 1 to 6
Extensions
EF 7 to 8
Optional 9 to 12
Trunk Ports
Installing IP500/IP500 V2
IP Office 9.0
· Supports
· IP500 Control Unit:
· IP500 V2 Control Unit:
· Maximum per Control Unit: 3.
· IP500 Trunk Card Support:
Features
· REN 1.
· DTMF dialing only.
· Message waiting indication 51V stepped.
· ICLID mode Bellcore 202.
LEDs
· No status LED are used for ETR ports.
· LED1 is also used for base card status:
· Red On = Error
· Red Slow Flash = Initializing.
· If fitted with an IP500 Trunk Daughter card, during power failure both these ports are
connected to analog trunk port 12.
· Supports ICLID modes DTMFA, DTMFC, DTMFD, FSK and UK20.
· REN 2 (1 for external bell device).
· Off-Hook current: 25mA
· Ring Voltage: 40V.
· Intended for connection to two-wire analog phones, the ports do not include a ringing
capacitor. For connection to 4-wire analog phones, connection should be via a master socket
with ringing capacitors.
· No status LEDs are used for analog phone extensions.
Depends on the type of trunk daughter card fitted. The ETR6 can be fitted with either a
Trunk card or PRI Trunk
235
LEDs
LED use depends on the type of daughter card installed on the base card:
· LED 9 is also used for daughter card status.
· Red On = Error
· Red Slow Flash = Initializing.
Analog · Green on = V1: Card installed. V2: Line connected to the port but idle.
Card
· Green flashing = Line in use.
PRI Card · Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
ETR and analog phones. Each ETR phone can be used for an ETR or
analog phone. Support for ETR 34D phone is limited to a maximum of
2 per ETR6 card and 4 in total.
· Paging to external paging equipment is not supported via ETR6
ports. It is supported via POT ports.
· The only analog phones tested by Avaya for IP500/IP500 V2 are
the Avaya 6200 Series. If other analog phones are used, it is the
customer's own responsibility to ensure that those phones work
as required.
This card is only supported by IP500 V2 systems running in IP Office
Basic Edition - PARTNER® Mode or IP Office Basic Edition (Mu-Law)
modes. The card is not supported in other systems or if the system is
changed to A-Law operation.
The IP500 BRI trunk daughter card is not supported.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
card.
238
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
1.
15-601042 Issue 28c (19 August 2013)
Analog
Page 228