Analog Trunk Cards (Atm4); Bri Trunk Cards - Avaya IP500 V2 Installation Manual

10.7.2 Analog Trunk Cards (ATM4)

The Analog Trunk card is also referred to as the "ATM4". It provides 4 RJ45 sockets for
card only supports loop-start trunks.
The card is available in a number of locale specific variants as detailed below.
· Power Failure Operation
There are no power failure extension connections provided for the analog trunk card.
WARNING
·
In all IP Office installations, any module or control unit using analog trunk connections must be connected to a
functional earth
44
WARNING
·
Within the Republic of South Africa and in areas of high lightning risk, any module or control unit using analog trunk
connections must be connected to a
ATM4 Trunk Cards
· These cards include two plastic stand off pillars for installation and a replacement blanking plate for the rear of
IP400 control units.

10.7.3 BRI Trunk Cards

The BRI trunk card is also referred to as the "Quad BRI". It provides 4 RJ45 sockets for ETSI BRI trunk connections, with
each trunk supporting 2B+D channels.
Variant
· The trunk card ports include 100 ohm termination.
· These cards include two plastic stand off pillars for installation and a replacement blanking plate for the rear of
IP400 control units.
· For the IP500 and IP500 V2 control units, an IP500 Carrier Card is required, up to a maximum of 2 IP500 Carrier
Cards.
Installing IP500/IP500 V2
IP Office 9.0
.
protective ground
IP400 Analog 4
(Loop-Start)
IP400 Analog 4 EU
(Loop-Start)
IP400 Analog 4 NZ
(Loop-Start)
IP400 BRI
IP400 BRI 8 (UNI)
System Components: IP400 Trunk Cards
and to surge protection equipment
44
Country SAP Code
North and South 700185192
America
Europe 700241672
New Zealand 700241706
Country SAP Code
All 700185168
All except China 700262017
analog trunk connections
.
45
IP500 IP500
V2
– –
– –
– –
IP500 IP500
V2
15-601042 Issue 28c (19 August 2013)
. The
390
Page 259