Wall Mounting Kit - Avaya IP500 V2 Installation Manual

4.6.1 Wall Mounting Kit V2/V3
These notes relate to the IPO IP500 RACK MNTG KIT V2 (SAP 700500923) and IPO IP500 RACK MNTG KIT V3 (SAP
700503160). These kits can be used to wall or rack mount IP500 V2 control units and IP500 external expansion modules.
The kits includes all components necessary for wall mounting onto a plywood surface. The use of the cable covers is
optional.
In addition to the existing
apply when wall mounting a unit:
· The wall surface must be vertical, flat and vibration free. Attachment to temporary walls is not supported.
· Only the screws provided with the mounting kit should used to attach the brackets to the control unit.
· The installation must be done by a service person only.
· For control units, the mesh flame screen must be installed on the bottom edge of the control unit before mounting.
· For the V3 kit, the flame screen attaches to the outside of the control unit.
· For the V2 kit, the flame screen is inserted inside the control unit chassis. To do this you must wait at least 15
minutes after removing the power cord before fitting the flame screen.
· Ensure that the system has been shutdown and power has been removed from all the units. Shutdown the system
using a shutdown command and then remove power. Do not simply remove the power.
· A suitable mounting surface of at least 19mm (0.75 inch) plywood is required.
· Full installation instructions are included with the kit.
Installing IP500/IP500 V2
IP Office 9.0
environmental requirements for an IP Office system, the following additional requirements
60
15-601042 Issue 28c (19 August 2013)
Page 88