Tcm8 Digital Station - Avaya IP500 V2 Installation Manual

Hide thumbs Also See for IP500 V2:
Table of Contents

Advertisement

10.3.9 TCM8 Digital Station

This card is used to add TCM RJ45 extension ports to an IP500 V2 control unit. It provides 8 RJ45 extension ports for
supported M-Series and T-Series digital stations. It can also be used for 4100 and 7400 Series phone support by
connection to a
Digital Mobility Solution
A further 4 RJ45 ports are provided for trunk connections when an IP500 trunk card is fitted to this card.
Port Type
Ports
TCM
1 to 8
Optional Trunk
9 to 12
Card Ports
Name
IPO 500 TCM 8 Extn Card Assy
Installing IP500/IP500 V2
IP Office 9.0
system.
367
· Supports
Provides 8 TCM ports for supported 4100, 7400, M and T-Series digital
stations.
· IP500 Control Unit:
· IP500 V2 Control Unit:
· Maximum per Control Unit: 4.
· IP500 Trunk Card Support:
Features
Cable lengths up to 305 m (1000 ft) using 0.5mm (24AWG) wires do not require a power
booster. For TCM phones, lengths up to 790 m (2600 ft) are supported if an auxiliary
power supply booster is used.
LEDs
· Green On = Phone detected.
· LED1 is also used for base card status:
· Red On = Error
· Red Slow Flash = Initializing.
The card can be fitted with one trunk daughter card of any type. The trunk daughter card
then uses ports 9 to 12 on the base card for its trunk connections.
LEDs
LED use depends on the type of daughter card installed on the base card:
· LED 9 is also used for daughter card status.
· Red On = Error
· Red Slow Flash = Initializing.
Analog Card
· Green on = V1: Card installed. V2: Line connected to the port
· Green flashing = Line in use.
PRI Card
· Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
· Red/Green Fast Flash (port 9) or Green Fast Flash (port
· Red with Green Blink (port 9) or Green Blink (port 10) =
BRI Card
· Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
Description
IP Office 500 TCM 8
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
but idle.
10) = Alarm indication signal (AIS) from the trunk remote end.
Port in loopback mode (set through IP Office System Monitor).
System Components: IP500 Base Cards
1.
SAP Code
700500758
15-601042 Issue 28c (19 August 2013)
Page 231

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ip500

Table of Contents