Tcm Phones; Ip/Sip Phones - Avaya IP500 V2 Installation Manual

4.13.4 TCM Phones

Connect any TCM phones to their appropriate TCM ports. These phones do not need to load additional firmware.
DS30B Module
The IP500 DS16B and DS30B external expansion modules support either TCM or DS ports. The port type for a whole
module is configured using IP Office Manager. See
Default Buttons
For system's with TCM phone ports, when a phone is first connected to the port, the button programming of the associated
user is overwritten with the default button programming appropriate for the phone model.
If the new system is being installed with a pre-staged configuration that include user button programming, the automatic
defaulting of buttons to match the phone type will overwrite the user button settings. This behavior can be prevented by
adding the following short code to the user's setup in the pre-programmed configuration:
· Code: *DCP
· Feature: Dial
· Telephone Number: 84000004,1,1,0
The 4000004 part of the string above can also be used to adjust the defaults for the following phone settings:
· The first digit sets the phone contrast = 1 (low) to 9 (high).
· The last digit sets the ringer volume = 0 (high) to 7 (low).
Note that subsequently removing this short code will cause the buttons to return to defaulting according to the phone
type.
Phone Type Setting
For some phones, the phone can only report its general type to the system rather than its specific model. It is
recommended that after connecting all the phones, the phone types should be correctly set in the IP Office configuration.
!
Important
·
The default types cannot be changed after installation without defaulting the configuration. Therefore you must
ensure that you connect the correct type of phone to each port. If you need to swap phones, uses the process for
exchanging extension numbers
1. Using IP Office Manager, receive the configuration from the system.
2. Select Extension.
3. Selecting each extension in turn, on the Extn tab, check that the Device Type field is set to the correct phone
model.
Default Type
T7100
T7208
M7310
M7310BLF
M7324
4. Save the configuration back to the IP Office system.

4.13.5 IP/SIP Phones

The installation and configuration of H323 and SIP IP telephones is not covered by this document. Refer to the appropriate
IP Office installation manual for the type of phone being installed.
Installing IP500/IP500 V2
IP Office 9.0
DS16B/30B Port Mode Selection
rather than swapping wiring.
168
Possible Phone Models
T7100, MT7100, MT7100N, Audio Conferencing Unit.
T7208, MT7208, MT7208N.
T7406E, T7406, M7310, M7310N
T7316, M7310BLF
M7324, M7324N
.
115
15-601042 Issue 28c (19 August 2013)
Page 100