Rack Space Requirements - Avaya IP500 V2 Installation Manual

2.2.4 Rack Space Requirements

All IP Office control units and external expansion modules can be rack mounted into standard 19" rack systems. Each unit
requires a 2U slot space within the rack. The IPO IP500 RACK MNTG KIT V3 is used for rack mounting of units.
Where IP Office systems are being rack mounted, the effect of conditions within the rack cabinet must be considered. For
example the rack temperature may be above the room temperature and airflow within the rack will be restricted. The
environmental requirements
Barrier Box Rack Mounting Kit
Rack Module Positioning
The integral expansion ports on a control unit are located on the rear of the unit. For IP500 and IP500 V2 control units, an
additional 4 expansion ports can be added to the front of the control unit by installing an IP500 4-Port Expansion card.
· Each external expansion module is supplied with a blue 1 meter (3'3'') expansion interconnect cable. This
cable must be used when connecting to expansion ports on the rear of a control unit.
· When connecting to expansion ports on an IP500 4-Port Expansion card, a yellow 2 meter (6'6") expansion
interconnect cable can be used in place of the standard blue cable. 4 Yellow cables are supplied with the IP500
4-Port Expansion card.
Installing IP500/IP500 V2
IP Office 9.0
for the individual IP Office units are still applicable inside the rack cabinet.
60
· Barrier Box Rack Mounting Kit (SAP 700293905)
Barrier boxes must be used for
extensions
be rack mounted and simplifies the number of connections to the
protective ground point in the rack. This kit must be used when more
than 3 barrier boxes are in use and supports a maximum of 16
barrier boxes for a single external expansion module.
out-of-building analog phone
. This bracket allows up to 8 IP Office barrier boxes to
45
15-601042 Issue 28c (19 August 2013)
Page 64