Phone - Avaya IP500 V2 Installation Manual

10.9.5 Phone

The IP400 Phone module (also known as the Phone V1 module) is used to add additional POT ports to an IP Office system.
POT ports are used for analog phones.
The Phone module is available in 8, 16 and 30 port variants, referred to as the Phone 8, Phone 16 and Phone 30
respectively. The IP400 Phone Module has been superseded by the
· With IP Office 3.1 and higher, the message waiting indication (MWI) on each POT port can be configured for None, On,
51V Stepped, 81V, Line Reversal A or Line Reversal B. On uses the default determined by the system locale. POT ports
on a Phone V2 module can additionally be configured for 101V operation.
Feature Details
Supported on All IP Office control units except Small Office Edition.
Locales Supported in all
Software Level IP Office core software level 1.0 minimum. Bin file = napots16.bin (earlier units, not supported on
IP500) or avpots16.bin (later units).
Included Power supply unit (see below) and Expansion Interconnect cable.
Power Supply The module is supplied with a 2-pin, 40W external power supply unit. The PSU has an integral
power cord for connection to the module's DC I/P socket. A locale specific
39
Mounting The module is designed as a free-standing module that can be stacked on or under other IP Office
modules. The module can be rack mounted in a 19" rack system using the optional IP400 Rack
Mounting Kit.
Dimensions Width: 445mm/17.5". Depth: 245mm/9.7". Height: 71mm/2.8"/2U.
Weight Unboxed: 3.1Kg/6.94lbs. Boxed: 4.4Kg/9.7lbs. (Based on Phone 30 V2).
Module Front
Installing IP500/IP500 V2
IP Office 9.0
IP Office locales
for the external PSU is required but is not supplied with the module.
Phone Module V2
.
51
.
272
IEC60320 C7 power cord
15-601042 Issue 28c (19 August 2013)
Page 274