Adjusting Rear Wheel Height - Invacare Action 5 Service Manual

SECTION 5—REAR WHEELS/FRONT CASTERS
« A » Standard
position (+25 mm)
« B » Medium Active
position (+50 mm)

Adjusting Rear Wheel Height

NOTE: For this procedure, refer to FIGURE 5.7.
1. Remove the rear wheel. Refer to Removing/Installing Rear Wheels paragraph.
2. Remove the lock nut and washer that secures the axle bracket to the axle plate
3. Align the axle bracket with one of the six adjustment holes on the axle plate.
4. Secure the axle bracket to the axle plate, at the desired height, with the lock nuts
(30-35 Nm) and washers.
5. The position of the axle bracket can be adjusted on the axle plate step less thanks
to the lock nut. Take care to save enough space between the wheel and armrest
skirt guard.
Install the rear wheel. Refer to Removing/Installing Rear Wheels paragraph.
6.
7. Repeat STEPS 1 to 5 for the other rear wheel.
NOTE: Both rear wheels MUST be set at the same position.
Adjustment
holes (6)
Axle bracket
Vertical axis of
the backrest
FIGURE 5.6 4 Possible Positions of Wheel Plate
Vertical axis of
the axle plate
FIGURE 5.7
Adjusting Rear Wheel Height
Axle plate
Washer
2 8
« C » Active
position (+75 mm)
« D » Very Active
position (+100 mm)
Locknut