®
4
Invacare
- STORM
7.20
Rear wheel suspension
7.20.1 Replacing the rear wheel suspension
WARNING: Danger of crushing!
The mobility device is very heavy. Injury hazard to hands and feet!
You should seek help from a second person.
Injury hazard caused by uncontrolled movement of the mobility device!
Switch the power supply off (ON/OFF key).
Engage the drive.
Before raising the vehicle, secure the wheels by blocking them with wedges.
Requirements:
5 mm Allen key
6 mm Allen key
T40 torx wrench
13 mm socket spanner
19 mm socket spanner
blade screwdriver
long wooden blocks, min. 14 x 14 x 30 cm
Dismantling the wheel suspension:
Remove the rear and the centre battery compartment cover as described in chapters 7.1.1
and 7.1.2.
Remove the rear light cover as described in chapter 7.1.4.
Pull the motor plug out of the power module.
Open the cable clamps and expose the motor cable.
Remove the drive wheel as described in chapter 7.18.1.
Remove the wheel hub as described in chapter 7.18.3.
Remove the splash guard as described in chapter 7.1.5.
Remove the motor/transmission unit as described in chapter.
MAX
SERVICE MANUAL
113