Queue Egress - Dell S4810 Reference Manual

queue egress

Assign a WRED Curve to all eight egress Multicast queues or designate the percentage for the Multicast
bandwidth queue.
S4810
Syntax
queue egress multicast linecard {slot number port-set number |
all} [wred-profile name | multicast-bandwidth percentage]
To return to the default, use the no queue egress multicast linecard
{slot number port-set number | all} [wred-profile name |
multicast-bandwidth percentage] command.
Parameters
linecard
number
port-set
number
all
wred-profile
name
multicast-
bandwidth
percentage
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.8.10
Version 7.5.1.0
Version 7.4.1.0
and 6.5.3.0
1362
Enter the keyword linecard then the line card slot number.
Enter the keywords port-set then the line card's port pipe.
The range is from 0 or 1.
Enter the keyword all to apply to all line cards.
(OPTIONAL) Enter the keywords wred-profile then your
WRED profile name in character format (16 character
maximum). Or use one of the pre-defined WRED profile
names.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
(OPTIONAL) Enter the keywords multicast-bandwidth
then the bandwidth percentage. The range is from 0 to
100%.
Introduced on the S4820T.
Introduced on the S4810.
Added support for multicast-bandwidth.
Introduced on the E-Series.
Quality of Service (QoS)