Linksys SPA9000 Administration Manual page 51

Configuring Phone Lines and Calling Routing Behavior
• User ID: Enter a user ID, such as 9000.
This entry must exactly match the user ID on the SPA400 Setup > SPA9000 Interface page,
User ID field. For more information, see
SPA9000, " on page
• Proxy: Enter the IP address of the SPA400.
• Register Expires: 60
This setting ensures that the SPA9000 and SPA400 are resynchronized every 60 seconds.
This setting ensures that any changes in settings are synchronized on both devices.
SPA9000 Voice > Line: Subscriber Information, Proxy and Registration
5. Also in the Proxy and Registration section, enter the following settings to ensure that calls
can be transferred and forwarded to the voice mail server:
• Set VMSP Bridge to all
• Set XFER Bridge Mode to all.
• Set CFWD Bridge Mode to all.
NOTES:
• SIP Port: You can keep the default value. Each line must have a unique SIP port (5060 for
Line 1, 5061 for Line 2, 5062 for Line 3, 5064 for Line 4).
• Contact List: The default value is
should leave the default value until after you confirm that the line is registered in the
Voice > Info page, Line Status section, Registration State field. Then you can configure the
Linksys Voice System Administration Guide
Configuring Line Interfaces on the SPA9000
"Configuring a SPA400 to Interoperate with the
85.
(required if this line is being used for SPA400 voice mail service).
, for the Auto Attendant. As a general practice, you
aa
49