Linksys SPA9000 Administration Manual page 193

Restrict Source IP
Referor Bye Delay
Refer Target Bye Delay
Referee Bye Delay
Refer-To Target Contact
Sticky 183
Voice tab > FXS 1/2 page
Subscriber Information section
Display Name
User ID
Voice tab > FXS 1/2 page
Dial Plan section
Dial Plan
Voice tab > FXS 1/2 page
Mailbox Status section
Message Waiting
Linksys Voice System Administration Guide
If line interfaces use the same SIP Port value and the Restrict Source IP
feature is enabled, the proxy IP address for Lines 1 and 2 is treated as an
acceptable IP address for both lines. To enable the Restrict Source IP
feature, select yes. Otherwise, select no.
A source IP address is untrusted if it does not match any of the IP
addresses resolved from the configured Proxy or Outbound Proxy if Use
Outbound Proxy is set to yes.
Default: no
Controls when the SPA9000 sends BYE to terminate stale call legs after
completion of call transfers. Multiple delay settings (Referor, Refer
Target, Referee, and Refer-To Target) are configured on this screen. For
the Referor Bye Delay, enter the appropriate period of time in seconds.
Default: 4
For the Refer Target Bye Delay, enter the appropriate period of time in
seconds.
Default: 0
For the Referee Bye Delay, enter the appropriate period of time in
seconds.
Default: 0
To contact the refer-to target, select yes. Otherwise, select no.
Default: no
If this feature is enabled, the IP telephony ignores further 180 SIP
responses after receiving the first 183 SIP response for an outbound
INVITE. To enable this feature, select yes. Otherwise, select no.
Default: no
Display name for caller ID.
Extension number for this line.
Dial plan script for this line.
Indicates whether you have new voicemail waiting.
Voice tab
191