Configuring Line Interfaces On The Spa9000; Configuring A Line Interface For Itsp Service - Linksys SPA9000 Administration Manual

Configuring Phone Lines and Calling Routing Behavior
• If the device is a fax machine, disable echo cancelling. On the FXS N page, Audio
Configuration section, set the FAX Disable ECAN field to yes. Also make sure that the
Preferred Codec is set to G.711u (default setting).
4. Enter the Dial Plan settings, as needed. See
5. Click Submit All Changes.

Configuring Line Interfaces on the SPA9000

You can configure the following types of services on the SPA9000 line interfaces:
• ITSP service: Up to 16 DID numbers can be supported on each line interface. You can
configure different ITSP accounts on different line interfaces.
• PSTN service: You can configure a line interface to register the SPA9000 with a SPA400
to support PSTN lines.
• SPA400 voice mail service: You can configure a line interface to register the SPA9000
with a SPA400 to support voice mail server. This SPA400 should have no more than two
PSTN lines connected. If more than two PSTN lines and voice mail are required, you
should reserve one SPA400 exclusively for voice mail. Exceeding these guidelines will
affect the quality of voice mail playback and command recognition.
• ISDN services: You can configure a line interface to register the SPA9000 with a
Mediatrix® 4400 ISDN BRI Digital gateway. For more information, refer to the SPA9000/
Mediatrix® 440X ISDN Gateway Configuration Guide, available at
(for Europe, Middle East and Africa Service Providers) and
Europe, Middle East and Africa Value Added Resellers).
This section includes the following topics:
• "Configuring a Line Interface for ITSP Service, " on page 46
• "Configuring a Line Interface for a SPA400 (PSTN or Voice Mail), " on page 48
• "Configuring Call Capacity for a Line Interface, " on page 51

Configuring a Line Interface for ITSP Service

1. Connect to the SPA9000 administration web server, and choose Admin access with
Advanced settings. (See
page 24.)
2. Click Voice tab > Line N, where N represents the line interface number.
3. From the Line Enable drop-down list, choose yes.
4. Enter the account information for your ITSP account:
User ID: The account number or logon name for your ITSP account (often the same as the phone
number)
Linksys Voice System Administration Guide
Configuring Line Interfaces on the SPA9000
"Configuring Dial Plans, " on page
"Connecting to the SPA9000 Administration Web Server, " on
52.
www.linksys-itsp.com
www.linksys-voip.eu (for
46