Linksys SPA9000 Administration Manual page 37

IVR Menu
IVR Action Choice
Enter IVR Menu * * * *
Exit IVR Menu 3948
Check DHCP 100
Enable/Disable 101
DHCP
Check WAN IP 110
Address
Set Static IP 111
Address
Check Network 120
Mask
Set Network Mask 121
Check Static 130
Gateway IP
Address
Linksys Voice System Administration Guide
Basic Administration of the SPA9000
Using the Interactive Voice Response Unit
Table 2-1 IVR Options
Parameter(s)
None
None
None
Enter 0 to enable
Enter 1 to disable
None
Enter IP address using
numbers on the
telephone key pad. Use
the * (star) key when
entering a decimal
point.
None
Enter value using
numbers on the
telephone key pad. Use
the * (star) key when
entering a decimal
point.
None
Notes
Ignore SIT or other tones until
you hear, "Linksys configuration
menu. Please enter option
followed by the pound key or
hang-up to exit. "
The IVR spells "S,T,A,T,I,C" if the
setting is for a static IP address or
"D,H,C,P" for a DHCP IP address.
Requires password
IVR announces the current IP
address of the WAN port.
DHCP must be "Disabled, "
otherwise you hear, "Invalid
Option, " if you try to set this
value. Hang up the phone after
setting the IP address. The
SPA9000 reboots and the new
address takes effect. Do not
attempt to use IVR option 110
immediately after changing the
IP address. The old IP address is
reported until the SPA9000
reboots.
Requires password
IVR announces the current
network mask of SPA.
DHCP must be "Disabled, "
otherwise you hear, "Invalid
Option, " if you try to set this
value.
Requires password
IVR announces the current
gateway IP address of SPA.
35