Sip Page - Linksys SPA9000 Administration Manual

Debug Level
Voice tab >

SIP Page

You can use the SIP page to enter many settings that are important for the proper functioning
of SIP on your SPA9000. This page includes the following sections:
• "SIP Parameters section, " on page 160
• "SIP Timer Values (sec) section, " on page 161
• "Response Status Code Handling section, " on page 163
• "RTP Parameters section, " on page 163
• "SDP Payload Types section, " on page 165
• "NAT Support Parameters section, " on page 166
• "PBX Parameters section, " on page 167
• "Internal Music Source Parameters section, " on page 170
• "Auto Attendant Parameters section, " on page 171
• "PBX Phone Parameters section, " on page 174
Voice tab > SIP page
SIP Parameters section
Max Forward
Max Redirection
Max Auth
SIP User Agent Name
SIP Server Name
Linksys Voice System Administration Guide
The level of debug information that is generated, from 0 to 3. 0 is a
minimal level of debugging information that is acceptable for most
Levels 1 to 3 are typically used only by Linksys
purposes.
personnel.
NOTE: Default: 0
SIP Max Forward value, which can range from 1 to 255.
Default: 70
Number of times an invite can be redirected to avoid an infinite loop.
Default: 5
Maximum number of times (from 0 to 255) a request may be challenged.
Default: 2
User-Agent header used in outbound requests. If empty, the header is
not included. Macro expansion of $A to $D corresponding to GPP_A to
GPP_D allowed.
Default: $VERSION
Server header used in responses to inbound responses.
Default: $VERSION
Voice tab
160