Linksys SPA9000 Administration Manual page 200

SIP Debug Option
Restrict Source IP
Referor Bye Delay
Refer Target Bye Delay
Referee Bye Delay
Refer-To Target Contact
Auth INVITE
Linksys Voice System Administration Guide
SIP messages are received at or sent from the proxy listen port. This
feature controls which SIP messages to log. Choices are as follows:
none—No logging.
1-line—Logs the start-line only for all messages.
1-line excl. OPT—Logs the start-line only for all messages except
OPTIONS requests/responses.
1-line excl. NTFY—Logs the start-line only for all messages except
NOTIFY requests/responses.
1-line excl. REG—Logs the start-line only for all messages except
REGISTER requests/responses.
1-line excl. OPT|NTFY|REG—Logs the start-line only for all messages
except OPTIONS, NOTIFY, and REGISTER
requests/responses.
full—Logs all SIP messages in verbose mode.
full excl. OPT—Logs all SIP messages in full text except OPTIONS
requests/responses.
full excl. NTFY—Logs all SIP messages in full text except NOTIFY
requests/responses.
full excl. REG—Logs all SIP messages in full text except REGISTER
requests/responses.
full excl. OPT|NTFY|REG—Logs all SIP messages in full text except for
OPTIONS, NOTIFY, and REGISTER requests/responses.
Default: None
If line interfaces use the same SIP Port value and the Restrict Source IP
feature is enabled, the proxy IP address for Lines 1 and 2 is treated as an
acceptable IP address for both lines. To enable the Restrict Source IP
feature, select yes. Otherwise, select no. A source IP address is untrusted
if it does not match any of the IP addresses resolved from the configured
<Proxy> (or <Outbound Proxy> if <Use Outbound Proxy> is yes).
Default: no
Controls when the SPA9000 sends BYE to terminate stale call legs upon
completion of call transfers. Multiple delay settings (Referor, Refer
Target, Referee, and Refer-To Target) are configured on this screen. For
the Referor Bye Delay, enter the appropriate period of time in seconds.
Default: 4
For the Refer Target Bye Delay, enter the appropriate period of time in
seconds.
Default: 0
For the Referee Bye Delay, enter the appropriate period of time in
seconds.
Default: 0
To contact the refer-to target, select yes. Otherwise, select no.
Default: no
When enabled, authorization is required for initial incoming INVITE
requests from the SIP proxy.
Line 1/2/3/4 page
198