Linksys SPA9000 Administration Manual page 157

DNS Query Mode
Primary NTP Server
Secondary NTP Server
DHCP IP Revalidate Timer:
Router tab > Wan Setup page >
MAC Clone Settings section
Enable MAC Clone Service
Cloned MAC Address
Router tab > Wan Setup page >
Remote Management section
Enable WAN Web Server
WAN Web Server Port
Router tab > Wan Setup page >
QOS Settings section
QoS Policy
QOS QDisc
Maximum Uplink Speed
Router tab > Wan Setup page >
VLAN Settings section
Enable VLAN
Linksys Voice System Administration Guide
The mode of DNS query: parallel or sequential
NOTE: With parallel DNS query mode, the SPA9000 sends the same DNS
lookup request to all the DNS servers at the same time, and the first
incoming reply is accepted by the SPA9000.
Default: parallel
The IP address or name of the primary NTP server
The IP address or name of the secondary NTP server
Enable if you need to assign a different MAC address to the SPA9000 via
the Cloned MAC Address field.
The MAC address that you need the SPA9000 to assume
Allows (yes) or prevents (no) access to the administration web server
from a computer that is not directly connected to the SPA9000.
Default: yes
The port that is used for WAN access to the SPA9000
Default: 80
The queueing discipline, set to none or token bucket filter (TBF). TBF
limits the rate of transmission to not attempt to exceed the Maximum
Uplink Speed.
Allow QoS Queuing. Options are None or TBF (token bucket filter).
Information can be found at about TBF at:
lartc.qdisc.classless.html
Define this value to allow the token bucket filter queueing discipline to
manage traffic flow to ensure high quality voice audio.
Enable voice data to be tagged with the defined VLAN ID.
NOTE: Choose yes If your SPA9000 is connected to a switch that uses
VLAN tagging.
Router Tab
http://lartc.org/howto/
155