Linksys SPA9000 Administration Manual page 49

Configuring Phone Lines and Calling Routing Behavior
Password: The password for your ITSP account
Proxy: The proxy server for your ITSP account
NOTES:
• SIP Port: You can keep the default value. Each line must have a unique SIP port (5060 for
Line 1, 5061 for Line 2, 5062 for Line 3, 5064 for Line 4).
• Contact List: The default value is
should leave the default value until after you confirm that the line is registered. Then
you can configure the contact list. For more information, see
with the Contact List, " on page
• Depending on your ITSP network configuration requirements, you may need to set
additional parameters such as Outbound Proxy. Service Provider will indicate the
setting of any additional parameter for each ITSP line.
5. Click the Submit All Changes button. The SPA9000 device reboots.
6. To verify the registration state, perform the following tasks:
• After the devices reboot, Click Voice tab > Info. Scroll down to the Line Status section for
the line that you configured (Line 1 Status ... Line 4 Status). Verify that the line is
registered. If the line is not registered, you may need to refresh the browser several
times because it can take a few seconds for the registration to succeed.
Linksys Voice System Administration Guide
Configuring Line Interfaces on the SPA9000
SPA9000 Voice > Line
, for the Auto Attendant. As a general practice, you
aa
66.
"Managing Inbound Calls
47