Line 1/2/3/4 Page - Linksys SPA9000 Administration Manual

Voice tab > FXS 1/2 page
FXS Port Polarity Configuration section
Idle Polarity
Caller Conn Polarity
Callee Conn Polarity
Voice tab >

Line 1/2/3/4 page

You can use the Line 1 - Line 4 pages to configure the line interfaces on your SPA9000. The line
interface page includes the following sections:
• "Line Enable section, " on page 196
• "Network Settings section, " on page 196
• "SIP Settings section, " on page 197
• "Subscriber Information section, " on page 199
• "Dial Plan section, " on page 199
• "NAT Settings section, " on page 199
• "Proxy and Registration section, " on page 200
Voice tab > Line page
Line Enable section
Line Enable
Voice tab > Line page
Network Settings section
SIP ToS/DiffServ Value
SIP CoS Value [0-7]
Linksys Voice System Administration Guide
Polarity before a call is connected: Forward or Reverse.
Default: Forward
Polarity after an outbound call is connected: Forward or Reverse.
Default: Forward
Polarity after an inbound call is connected: Forward or Reverse.
Default: Forward
To enable this line for service, select yes. Otherwise, select no.
Default: yes
TOS/DiffServ field value in UDP IP packets carrying a SIP message.
Default: 0x68
CoS value for SIP messages.
Default: 3
Line 1/2/3/4 page
196