Using The Ivr With An Sas Line; Example Sas With Moh - Linksys SPA9000 Administration Manual

If no calls are in session, battery is removed from tip-and-ring of the FXS port. Some audio
source devices have an LED to indicate the battery status. This can be used as a visual indication
as to whether audio streaming is in progress.
Set up the Proxy and Subscriber Information for the SAS Line as you normally would with a
regular user account.
Call Forwarding, Call Screening, Call Blocking, DND, and Caller-ID Delivery features are not
available on an SAS line.

Using the IVR with an SAS Line

The IVR can still be used on an SAS line, but the user needs to follow the following steps:
1. Power off the SPA9000.
2. Connect a phone to the port and make sure the phone is on-hook.
3. Power on the SPA9000.
4. Pick up handset and press * * * * to invoke IVR in the usual way.
If the SPA9000 boots and finds that the SAS line is on-hook, it does not remove battery from the
line so that IVR may be used. But if the SPA9000 boots up and finds that the SAS line is off-hook,
it removes battery from the line because no audio session is in progress.

Example SAS with MOH

Figure 6-1 MOH Application with a SPA9000 Line Configured as an SAS
SPA1:
IP=192.168.2.100
UserID[1]=1001, SIP Port[1]=5060
UserID[1]=1002, SIP Port[1]=5061
Phone 1
Phone 2
Music
source
In this example, the SAS Line is registered with the SPA9000 as the other subscribers.
Linksys Voice System Administration Guide
IP Network
Media
signal
adapter
Line in
Configuring Music on Hold
Configuring a Streaming Audio Server
SPA2:
IP=192.168.2.200
UserID[1]=2001, SIP Port[1]=5060
UserID[1]=2002, SIP Port[1]=5061
Phone 1
Phone 2
100