Linksys SPA9000 Administration Manual page 187

Feature Dial Services Codes
Media Loopback Code
Voice tab > Regional page
Vertical Service Announcement Codes section
Service Annc Base Number
Service Annc Extension
Codes
Linksys Voice System Administration Guide
These codes tell the Linksys ATA what to do when the user is
listening to the first or second dial tone.
One or more *code can be configured into this parameter, such as
*72, or *72|*74|*67|*82, etc. Max total length is 79 chars. This
parameter applies when the user has a dial tone (first or second
dial tone). Enter *code (and the following target number
according to current dial plan) entered at the dial tone triggers
the Linksys ATA to call the target number prepended by the
*code. For example, after user dials *72, the Linksys ATA plays a
prompt tone awaiting the user to enter a valid target number.
When a complete number is entered, the Linksys ATA sends a
INVITE to *72<target_number> as in a normal call. This feature
allows the proxy to process features like call forward (*72) or
BLock Caller ID (*67).
The *codes should not conflict with any of the other vertical
service codes internally processed by the Linksys ATA. You can
empty the corresponding *code that you do not want to Linksys
ATA to process.
You can add a parameter to each *code in Features Dial Services
Codes to indicate what tone to play after the *code is entered,
such as *72'c'|*67'p' . Below are a list of allowed tone parameters
(note the use of back quotes surrounding the parameter w/o
spaces)
• 'c' = <Cfwd Dial Tone>
• 'd' = <Dial Tone>
• 'm' = <MWI Dial Tone>
• 'o' = <Outside Dial Tone>
• 'p' = <Prompt Dial Tone>
• 's' = <Second Dial Tone>
• 'x' = No tones are place, x is any digit not used above
If no tone parameter is specified, the Linksys ATA plays Prompt
tone by default.
If the *code is not to be followed by a phone number, such as *73
to cancel call forwarding, do not include it in this parameter. In
that case, simple add that *code in the dial plan and the Linksys
ATA send INVITE *73@..... as usual when user dials *73.
Default: *03
Base number for service announcements.
Extension codes for service announcements.
Voice tab
185