Using The Ivr Menu - Linksys SPA9000 Administration Manual

• "Using the IVR Menu, " on page 34
• "Entering a Password through the IVR, " on page 37

Using the IVR Menu

To use the IVR menu, complete the following steps.
1. Connect an analog telephone to the Phone 1 or Phone 2 port of the SPA9000.
2. Press **** (quickly press the star key four times).
3. Wait until you hear "Linksys configuration menu. "
4. Refer to Table 2-1 to identify the option required.
5. Enter the required option followed by the # (pound) key.
NOTE:
• To enter a period, use the star key (*).
• When entering a value, such as an IP address, to exit without entering any changes,
press the * (star) key twice within half a second. Otherwise, the * is treated as a decimal
point.
• After entering a value, such as an IP address, press the # (pound) key to indicate you
have finished your selection.
• To save a new setting, press 1. To review a new setting, press 2. To re-enter a setting,
press 3. To cancel your entry and return to the main menu, press * (star).
For example, to enter the IP address 191.168.1.105 by keypad, press the following keys:
191*168*1*105. Press the # (pound) key to indicate that you have finished entering the
IP address. Then press 1 to save the IP address, or press the * (star) key to cancel your
entry and return to the main menu.
• If the menu is inactive for more than one minute, the SPA9000 times out. You need to re-
enter the menu by pressing ****.
6. To exit the menu, hang up the telephone.
The settings that you have saved take effect after you hang up the telephone. The SPA9000
may reboot at this time.
Linksys Voice System Administration Guide
Basic Administration of the SPA9000
Using the Interactive Voice Response Unit
34