Voice Tab Info Page - Linksys SPA9000 Administration Manual

Voice tab > Info page >
Product Information section
Product Name
Serial Number
Software Version
Hardware Version
MAC Address
Client Certificate
Customization
Licenses
Voice tab > Info page >
System Status section
Current Time
Elapsed Time
Voice tab > Info page >
FXS 1/2 Status section
Hook State
Message Waiting
Call Back Active
Last Called Number
Last Caller Number
Call 1/2 State
Call 1/2 Tone
Call 1/2 Encoder
Call 1/2 Decoder
Linksys Voice System Administration Guide
The model number of the SPA9000
The serial number of the SPA9000
The version number of the SPA9000 software
The version number of the SPA9000 hardware
The MAC address of the SPA9000
The status of the client certificate, which authenticates the SPA9000 for
use in the ITSP network
For an remote configuration (RC) unit, this field indicates whether the
unit has been customized or not. Pending indicates a new RC unit that is
ready for provisioning. If the unit has already retrieved its customized
profile, this field displays the name of the company that provisioned the
unit.
When populated with the value K0, indicates that the SPA9000 is
licensed for up to 16 users; if this field is blank, install firmware version
5.2.5 or higher.
The current date and time of the system; for example, 10/3/2003
16:43:00
The total time elapsed since the last reboot of the system; for example,
25 days and 18:12:36
The readiness of the device that is connected to the corresponding
Phone port on the SPA9000
• On: Ready for use
• Off: In use
Indicates whether the station assigned to the FXS port has new
voicemail waiting: Yes or No
Indicates whether a call back request is in progress: Yes or No
Last number called
Number of the last caller if available from caller ID, example 4085551212
Status of the call:, Ringing, Idle, or Connected
Type of tone used by the call, for example Ring Back 2 for inbound call or
None for outbound call
Codec used for encoding
Codec used for decoding
Voice tab
157