Linksys SPA9000 Administration Manual page 201

Voice tab > Line page
Subscriber Information section
Display Name
User ID
Password
Use Auth ID
Auth ID
Call Capacity
Contact List
Cfwd No Ans Delay
Voice tab > Line page
Dial Plan section
Dial Plan
Voice tab > Line page
NAT Settings section
NAT Mapping Enable
NAT Keep Alive Enable
NAT Keep Alive Msg
Linksys Voice System Administration Guide
Display name for caller ID.
User ID assigned by the ITSP, often the same as the DID.
Password for this User ID.
To use the authentication ID and password for SIP authentication, select
yes. Otherwise, select no to use the user ID and password.
Default: no
Authentication ID for SIP authentication.
Maximum number of calls allowed on this line interface. You can set a
value from 1 to 15, or leave the setting as unlimited. Note that the
SPA9000 does not distinguish between incoming and outgoing calls
when talking about call capacity. Note: unlimited = 16.
Default: unlimited
List of client stations that the SPA9000 alerts when there is an incoming
call to the line interface from the ITSP.
Delay, in seconds, before the call forwarding of no-answer calls feature is
triggered.
Default: 20
Dial plan script for this line.
Default: (xx.) The Dial Plan strips off the steering digit prior to sending
the dialed number to the ITSP.
To use externally mapped IP addresses and SIP/RTP ports in SIP
messages, select yes. Otherwise, select no.
Default: no
To send the configured NAT keep alive message periodically, select yes.
Otherwise, select no.
Default: no
Enter the keep alive message that should be sent periodically to
maintain the current NAT mapping. If the value is $NOTIFY, a NOTIFY
message is sent. If the value is $REGISTER, a REGISTER message without
contact is sent.
Default: $NOTIFY
Line 1/2/3/4 page
199