Config: Ip  Setup - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Front Panel Operation
All printable ASCII characters are available with the exception of the backslash (ASCII code 92)
and ~ (ASCII code 126).
Press ENTER after composing the SNMP Traps Community String. All trailing spaces are removed
from the string upon entry.
CONFIG: IP  SNMP  Traps  Version
SNMP Traps Version:
SNMP-ver1
Use the ◄ ► arrow keys to select SNMP-ver1 or SNMP-ver2, and then press ENTER.
CONFIG: IP  SNMP  Traps  Address
Trap IP addr #1:
000.000.000.000
To edit the SNMP Trap Destination's IP Address, use the
and then use the
To disable SNMP Traps, set both Trap IP Addresses as 000.000.000.000.
6.2.1.13.3 CONFIG: IP  Setup
IP Setup: Mode
MAC-Learning VLAN QoS Stats FrmSize ()
◄ ►
Use the arrow keys to select Mode, WAN, PerPortCnfg, DDMgmtPt, MAC-Learning, VLAN,
QoS, Stats, or FrmSize, and then press ENTER.
If the optional IP Packet Processor card is installed and enabled
and VLAN options are selectable but non-functional.
CONFIG: IP  IP Setup  Mode
Working Mode: Router Point to Point
(ManagedSwitch,R-PtoP, R-MPHub,R-MPRm)()
Use the ◄ ► arrow keys to select ManagedSwitch, R-PtoP (Router Point-to-Point), R-MPHub
(Router Multipoint-to-Hub), or R-MPRm (Router Multipoint-to-Remote), and then press ENTER.
If the optional IP Packet Processor card is either not installed or installed but
disabled, the mode is "Fixed at Managed Switch Mode".
(ver1,ver2)
arrow keys to change that digit.
▲▼
WAN
◄ ► arrow keys to select a digit to edit,
PerPortCnfg DDMgmtPt
6–55
Revision 0
MN-CDM625A
()
()
, then both the PTP