Table of Contents
Advertisement
CDM-625A Advanced Satellite Modem
Front Panel Operation
When the unit is connected to a 1:N switch, a red LED located on the rear panel
labeled "1:N Active!" indicates that caution is required, as there may be DC voltages
and other control signals present on certain pins on the 25-pin Data Interface
connector.
6.2.6.6
Utilities: Circuit-ID
Edit this Modem's Circuit ID:
----------------------------------------
To compose a Circuit ID string – On the bottom line, first use the
alphanumeric character space to edit, and then use the
You may use the following characters to compose a Circuit ID string of up to 40 characters in
length or a MetaCarrier Custom Message of 24 characters or less:
Press ENTER once you finish composing the Circuit ID string. As created here, in addition to the
front panel VFD, the Circuit ID also appears in the title bar of compatible web browsers for easy
unit identification.
Proper composition of the Circuit ID string is dependent on whether the Carrier ID
(MetaCarrier) feature operation is enabled or disabled (see Sect. 6.2.6.3 Utilities:
CarrID):
1. With Carrier ID enabled , the first 24 characters of the 40-character Circuit ID
2. With Carrier ID disabled , the Circuit ID full 40 character length is available for
[Space] ( ) * + - , . / 0-9 and A-Z.
are intended for and sent as the MetaCarrier Custom Message. While you
must limit your MetaCarrier Custom Message to 24 characters or less, the full
40 characters of the Circuit ID will display on the front panel screen saver (see
Sect. 6.1.3.1 Screen Saver).
creation of the unit identification label that displays on the front panel VFD
screen saver and the Web browser title care.
arrow keys to edit that character.
▲▼
6–85
Revision 0
MN-CDM625A
()
◄ ►
arrow keys to select the
Advertisement
Chapters
Table of Contents
