Comtech EF Data CDM-625A Installation And Operation Manual page 629

Advanced satellite modem (18 kbps – 25 mbps)
Hide thumbs Also See for CDM-625A:
Table of Contents

Advertisement

L.1
Introduction
The IP Packet Processor is an optional feature for the CDM-625A Advanced Satellite Modem. In
addition to providing Layer 3 functionality, it incorporates a number of key features for Wide
Area Network (WAN) bandwidth optimization, including very low overhead Streamline
Encapsulation (SLE), Header Compression, Payload compression, Advanced Quality of Service
(QoS), and Advanced Encryption Standard (AES) Encryption.
The IP Packet Processor enables efficient IP networking and transport over satellite, in either
Router Mode or Managed Switch Mode, by adding routing capability with very low overhead
encapsulation, header compression, payload compression, and Quality of Service (QoS). The
Advanced QoS combined with header and payload compression ensures the highest quality of
service with minimal jitter and latency for real-time traffic, priority treatment of mission critical
applications and maximum bandwidth efficiency.
L.1.1
IP Packet Processor – Operational Requirements
The IP Packet Processor is available as a factory-installed option or, depending on
its originally shipped configuration, as a field-upgradeable option. Use of the IP
Packet Processor with the CDM-625A Advanced Satellite Modem requires the
following:
CDM-625A Power Requirements for the IP Packet Processor Board (CEFD P/N
PL-0000481): When ordering the IP Packet Processor as a factory installed option, the
modem power supply that is specified at the time of order must either be 175 watts
for AC units, or 125 watts for DC units.
Existing field units that meet either power supply configuration requirement are
user-upgradable in the field using CEFD Kit KT-0000176 – refer to Section 18.5 in this
chapter for the field upgrade procedure using this kit.
However, existing field units that do not meet these power supply configuration
requirements – i.e., units that are configured with 65W AC or 65W DC power supplies
– must be returned either to Comtech EF Data or sent to a Comtech EF Data
Appendix L. IP PACKET
PROCESSOR OPTION
L–1

Advertisement

Table of Contents
loading

Table of Contents