CDM-625A Advanced Satellite Modem
Front Panel Operation
•
Delete the selected VLAN ID. After targeting a VLAN ID for deletion, use the
keys to select the ACT parameter, and then use the
Press ENTER to execute deletion of the selected VLAN ID.
CONFIG: IP IP Setup VLAN VLAN-Table Add-Entry
VLAN ID:????
P3:Tagged
To add new entries to the VLAN table:
•
First, use the
parameter.
Then, use the
•
•
Next, use the
use the
or Untagged.
•
Once you assign the VLAN ID and the port behavior attributes, press ENTER to create
the new entry. You are then returned to the previous menu.
Note the following:
•
If you attempt to add an entry that is named identically to an existing VLAN ID, an error
message displays as follows:
•
ERROR: vid already exists in table
•
If you attempt to add a new entry, and the VLAN table has already reached the 32
maximum allowable entries, an error message displays as follows:
Can not add new entry!
VLAN table is FULL!
You must take into consideration that, when deleting VLAN IDs, an entry
associated with an enabled PVID cannot be deleted
P1:Tagged
P4:Untagged
◄ ►
arrow keys to select the ???? character string following the VLAN ID:
arrow keys to replace the string with a new VLAN ID.
▲▼
Hold down the ▲▼ arrow keys to quickly scroll between 1 and 4095.
◄ ►
arrow keys to select the port (P1/Port1 through P4/Port4), and then
arrow keys to set the behavior attribute for that port as Tagged, Filtered,
▲▼
The port attribute assignment restrictions explained previously apply.
▲▼
P2:Tagged
ADD ()
6–61
Revision 0
MN-CDM625A
◄ ►
arrow keys to select ACT=Del.
.
arrow