Table of Contents
Advertisement
Appendix C. TCP/IP Ethernet
C.1
Introduction
The modem supports SNMP, FTP protocols and the Web Browser. Use of the protocols depends
on the correct setup of the TCP-IP menus. Use this document only as a guideline for setting up
the TCP-IP menus.
Contact the IT manager for guidance to make sure setup is successful. For additional information
on the WEB or SNMP configurations and descriptions, see the Remote Protocol Manual (TM117).
C.2
TCP/IP Network Configuration
Each unit requires configuration with the correct network settings. Contact the IT manager for
valid IP address mask, modem, server and router IP addresses.
1.
Use the dumb terminal System menu.
2.
Select the TCP / IP sub menu.
3.
Enter the TCP / IP menu.
These sub menus will show, but their order can vary.
C.2.1 Boot Mode Submenu
Use the BootMode submenu to select the operating boot mode for the TCP/IP. Several
selections are available.
When configuring the modem for the Web Browser, you must set Boot Mode to
NON-VOL.
The DMD1050TS is set with the Boot Mode configured as Default when shipped from the factory.
Verify that the Boot Mode is Default.
To access the unit via the Ethernet port, set the Boot Mode to IP TEST. This sets the IP
parameter to an accessible address. To use an alternate address, set the Boot Mode to NON-
VOL.
As an example, we will use a new modem IP address of 172.018.100.205 for the remaining of the
TCP-IP setup procedure. Contact the IT manager for guidance to make sure setup is successful.
Appendix C
DMD1050TS Satellite Modem Board
C–1
Revision 1
Setup
MN-DMD1050TS
Advertisement
Chapters
Table of Contents
