Config: Misc; Config: Misc  G.703-Linecode (Ternary Code); Config: Misc  Idr-Esc - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Front Panel Operation

6.2.1.10 CONFIG: Misc

Misc:
Audio-Vol HiRateESC WarmUp Stats MEO ()
Use the ◄ ► arrow keys to select G.703-LineCode, IDR-ESC, HSSI, RTS, Audio-Vol, HiRateESC,
WarmUp, Stats, or MEO and then press ENTER.
6.2.1.10.1 CONFIG: Misc  G.703-LineCode (Ternary Code)
Parameters are editable only when the Data Interface Type is G.703.
Tx G.703/DDO Code= AMI
Rx G.703/IDI Code= AMI
The choices displayed here depend on the selected G.703 interface type. Use the
keys to select either the G.703 Tx or Rx Ternary Code, and then use the
the desired code. Press ENTER when done. The available choices are as follows:
Selection
HDB3
B8ZS
B6ZS
AMI
6.2.1.10.2 CONFIG: Misc  IDR-ESC
Parameters are editable only when the Framing Mode is IDR.
IDR-ESC-Type Tx:64k Data
Use this menu to determine if the 64 kbps channel in the IDR Engineering Service Channel (ESC)
overhead, normally reserved for the two 32 kbps ADPCM audio channels, should instead carry
user data. The rear panel Overhead connector provides the appropriate EIA-422 interface for
this option.
G.703-LineCode
For:
E1, E2 or sub-rate operation
T1 and Unbalanced T2 operation
Balanced T2 operation
Rx:64k Data
6–43
IDR-ESC HSSI
(AMI,B8ZS)
(AMI,B8ZS) ()
(64kData,Audio)
()
Revision 0
MN-CDM625A
RTS
◄ ► arrow
arrow keys to select
▲▼