Odu: Fsk-Control  Csat - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
CDM-625A ODU (Transceiver, BUC, LNB) Operation
10.3.3.3.3.1 ODU: FSK-control  CSAT
The CSAT menus that follow assume that you have already selected, and the
system has identified, a (standalone) CSAT connected via the rear panel Rx IF port.
When the following menu selections are made:
You are directed to a common submenu branch:
CSAT-5060/050 V1.02
Configuration
For clarity, this common submenu branch and its nested menus are defined in this
section. (CSAT#X denotes CSAT#1 or CSAT#2.)
Use the ◄ ► arrow keys to select Configuration, Monitor, Alarms, or Info, and then press
ENTER.
ODU: FSK-control  CSAT (2CSATs  CSAT #X) 
10.3.3.3.3.1.1
Configuration
Configuration settings:
Use the ◄ ► arrow keys to select Tx, Rx, LNA, or Misc, and then press ENTER.
10.3.3.3.3.1.1.1
Tx: Fq=6247.0 MHz
Mute=Unmuted
◄ ►
Use the arrow keys to select the setting to edit, and then use the
that setting:
Selection
Fq
At
Amp
•
ODU: FSK-control 
• ODU: FSK-control

•
ODU: FSK-control 
Monitor
Tx Rx
ODU: FSK-control  CSAT (2CSATs  CSAT #X) 
Configuration  Tx
Slope: xxx, Cal
Setting
(Tx Frequency) 3625-4200 MHz, in steps of 1.0 or 2.5 MHz
(Tx Attenuation ) 0 to 25 dB, in increments of .25dB
(Amplifier setting ) Off or On
CSAT
2CSATs CSAT#1

2CSATs  CSAT#2
Alarms Info()
LNA Misc
Att=23.00 dB Amp=On
10–15
MN-CDM625A
()
()
arrow keys to edit
▲▼
Revision 0