Table of Contents
Advertisement
CDM-625A Advanced Satellite Modem
Ethernet-based Remote Product Management
7.5
Web Server (HTTP) Interface
A user-supplied Web browser allows the full monitor and control (M&C) of the CDM-625A from
its Web Server Interface. The CDM-625A's embedded web application is designed for, and works
best with, Microsoft's Internet Explorer Version 9.0 or higher. Comtech EF Data does not
recommend setting your browser to IE7 Compatibility Mode.
7.5.1
User Login
Type the CDM-625A's IP Address (shown here as http://xxx.xxx.xxx.xxx) into the Address area of
the user PC Web browser:
The Login window will appear, similar to the
example shown here, opens. Enter the
assigned User name and Password. The Web
Server Interface default user names and
passwords are as follows:
•
Admin
•
Read/Write
•
Read Only
HTTP Login User Access Levels are further defined as follows:
Admin User
Full Access to all
web pages.
Type the User Name and Password, and then
click [OK].
Once the valid User Name and Password is
accepted, you will see the CDM-625A Web
Server Interface "splash" page, as per the
following example (note that the Base
Modem and optional IP Packet Processor
Firmware Versions listed here are subject to
change):
To properly access the CDM-625A Web Server Interface, you must first configure remote control
access for the unit to Ethernet mode. If you attempt to log in to the Web Server Interface and
comtech/comtech
opcenter/1234
monitor/1234
HTTP Login User Access Level
Read/Write User
No Access to Admin or IP Packet Processor-
related web pages.
Full Access for all other web pages
Read Only User
No Access to Admin or IP Packet Processor-
related web pages.
View Only Access for all other web pages.
7–8
Revision 0
MN-CDM625A
Advertisement
Chapters
Table of Contents
