Config: Ip  Setup - Comtech EF Data CDM-625 Installation And Operation Manual

Advanced satellite modem (18 kbps – 25 mbps)

Hide thumbs Also See for CDM-625:

Table of Contents

CDM-625 Advanced Satellite Modem

Front Panel Operation

All printable ASCII characters are available with the exception of the backslash (ASCII code 92)

and ~ (ASCII code 126).

Press ENTER after composing the SNMP Traps Community String. All trailing spaces are removed

from the string upon entry.

CONFIG: IP  SNMP  Traps  Version

SNMP Traps Version:

arrow keys to select SNMP-ver1 or SNMP-ver2, and then press ENTER.

CONFIG: IP  SNMP  Traps  Address

Trap IP addr #1:

000.000.000.000

To edit the SNMP Trap Destination's IP Address, use the

and then use the

To disable SNMP Traps, set both Trap IP Addresses as 000.000.000.000.

5.2.1.13.3 CONFIG: IP  Setup

IP Setup: Mode

MAC-Learning VLAN QoS Stats FrmSize ()

arrow keys to select Mode, WAN, PerPortCnfg, DDMgmtPt, MAC-Learning, VLAN,

QoS, Stats, or – displayed only on modems with Hardware Version 2.X or higher – FrmSize, and

then press ENTER.

If the optional IP Packet Processor card is installed and enabled, then both the PTP

and VLAN options are selectable but non-functional.

CONFIG: IP  IP Setup  Mode

Working Mode: Router Point to Point

(ManagedSwitch,R-PtoP, R-MPHub,R-MPRm)()

arrow keys to select ManagedSwitch, R-PtoP (Router Point-to-Point), R-MPHub

(Router Multipoint-to-Hub), or R-MPRm (Router Multipoint-to-Remote), and then press ENTER.

arrow keys to change that digit.

arrow keys to select a digit to edit,

PerPortCnfg DDMgmtPt