Table of Contents
Advertisement
CDM-625A Advanced Satellite Modem
Front Panel Operation
If selecting ULL from the FEC menu, the options appear as shown:
Demod=BPSK
FEC Rate=0.493 (Fixed)
6.2.1.4.5 CONFIG: Rx Data
Rx Data Rate
◄ ►
Use the
arrow keys to select Rx Data Rate or Rx Sub-Mux, and then press ENTER.
If Rx Sub-Mux is ON, this menu provides read-only IP Info Rate information on the bottom line,
as shown:
Rx Data Rate
(IP Info Rate: 01200.340 kbps)
CONFIG: Rx Data Rx Data Rate
Rx Data Rate = 01544.000 kbps
Data Invert=Off
Use the top line to edit the Rx Data Rate. The bottom line permits selection of the Data
Inversion or the Clock Inversion features (added for compatibility with certain older equipment).
On the top line – To edit the Rx Data Rate, use the
then use the
▲▼
The maximum limits for the Rx Data Rate are 18kbps to 25Mbps. The actual minimum and
maximum data rates are dependent on Framing mode, Interface type, Modulation type and FEC
Code Rate. If you change any of the higher-priority parameters – causing the data rate to
become invalid – the Data Rate adjusts automatically. The installed FAST option(s) also dictate
the upper range of data rate.
When configuring for D&I or IDR framing or for G.703 interface type, the
through only the available data rates. If you edit the data rate to 1920 kbps while in D&I
framing, a message appears to indicate that E1 Fixed Channel Mode is implemented.
When G.703 is used, three auxiliary rates – 512, 1024, and 2048 kbps – are available as indicated
by the word AUX appearing to the right of the decimal place (for example, 00512.AUX
kbps).
AUX G.703 Data Rate Connectors Reference: Sect. 3.3.2.5 G.703 IDI (Insert Data In),
DDO (Drop Data Out) Connectors in Chapter 3. REAR PANEL CONNECTORS
PINOUTS.
(B,Q)
Rx Sub-Mux
Rx Sub-Mux
Clock Invert=Off
arrow keys to change that digit. Press ENTER when done.
()
◄ ►
arrow keys to select a digit to edit, and
6–27
Revision 0
MN-CDM625A
()
()
()
arrow keys scroll
▲▼
AND
Advertisement
Chapters
Table of Contents
