Using The Telnet Interface For Telnet Command Line Interface (Cli) Operation - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Ethernet-based Remote Product Management
7.4.2 Using the Telnet Interface for Telnet Command Line Interface (CLI)
Operation
Chapter 9. TELNET COMMAND LINE INTERFACE (CLI) OPERATION
Figure 7-1. CDM-625A Telnet Command Line Interface (CLI)
1. The CDM-625A Telnet Command Line Interface (CLI) is accessible only when
2. The CDM-625A Telnet CLI uses Telnet TCP Port 107 . Be sure to specify this port
3. The HyperTerminal terminal emulator, while compatible for use with remote
(LEFT) TeraTerm CLI Example
(RIGHT) PuTTY CLI Example
the optional IP Packet Processor is installed and enabled .
when configuring your terminal emulator for CLI operation.
control operations, is not
operation. Instead, for best results Comtech EF Data recommends PuTTY or
Tera Term or as the preferred terminal emulators (
supported or recommended for CDM-625A Telnet CLI
7–7
Revision 0
MN-CDM625A
Figure 7-1 ).