Comtech EF Data CDM-625A Installation And Operation Manual page 308

CDM-625A Advanced Satellite Modem
Serial-based Remote Product Management
Command
Parameter Number of
(Instruction
Type Arguments
& Qualifier)
Rx Terminal N/A 10 bytes
Frequency
Receive REE= 1 byte
Equalizer
Enable and Rx
Alpha
Rx Info Rate N/A 9 bytes, numeric
Rx Sub-Mux IP N/A 9 bytes, numeric
Info Rate
Description of Arguments
Query only.
Rx Terminal Frequency, which is the frequency (MHz) being received from the satellite.
Note: For additional information refer to Chapter 6 for LO, MIX, and Spectrum Settings.
Resolution=100 Hz
Returns 00000.0000 if LNB LO is zero
Example: RTF=11650.2249 (MHz)
Command or Query.
Rx Equalizer and Rx Alpha in the form x, where:
0=Rx Equalizer Disabled and Rx Alpha=0.35
1=Rx Equalizer Enabled and Rx Alpha=0.35
2=Rx Equalizer Disabled and Rx Alpha=0.12
3=Rx Equalizer Enabled and Rx Alpha=0.12
The default is 0.
Query only.
Allows remote access to the Aggregate Rx Information rate in the form ddddd.ddd
Query only.
Allows remote access to the IP portion of the Rx Information rate in the form ddddd.ddd
8–26
Revision 0
MN-CDM625A
Query
Response to
(Instruction & Response to Query
Command
Qualifier)
N/A RTF? RTF=xxxxx.xxxx
(see Description of
Arguments)
REE= REE? REE=x
REE?
REE* (see Description of
REE# Arguments)
RIR? RIR? RIR=ddddd.ddd
RIR=
RIR* (see Description of
RIR# Arguments)
RMI? RMI? RMI=ddddd.ddd
RMI=
RMI* (see Description of
RMI# Arguments)