Comtech EF Data CDM-625A Installation And Operation Manual page 165

CDM-625A Advanced Satellite Modem
Front Panel Operation
The actual negotiated speed (NegoSpeed:) is provided here as a read-only status display.
On the bottom line – Use the
following:
Selection Function
Sets the port speed as Auto Negotiated. This allows the ports to negotiate speed and half/duplex
Auto
operation.
100Full Forces the Port to 100/Full.
100Half Forces the Port to 100/Half.
10Full Forces the Port to 10/Full.
10Half Forces the port to 10/Half.
CONFIG: IP  IP Setup DDMgmtPt (Dedicated Management Port)
Dedicated Management Port: Port1
(Disabled,Port1,Port2,Port3,Port4) ()
Dedicated Management Port mode is not available when the optional IP Packet
Processor card is installed and enabled . Should you attempt to execute this
command under such a configuration, the screen is non-functional, and appears as
follows:
Dedicated Management Port: Disabled
(Fixed @ Disabled with PktP Present) ()
Use Dedicated Management Port mode in redundancy applications. When a redundant CDM-
625A is Offline (Standby), all four of the offline modem's Ethernet ports are disabled unless you
configure one of the four ports as the 'Dedicated Management Port.'
Use the arrow keys to set the 'Dedicated Management Port' as Disabled, or select one of
▲▼
the Ethernet ports (Port1, Port2, Port3 or Port4). Press ENTER when done.
arrow keys to edit the desired speed setting. Note the
▲▼
6–57
Revision 0
MN-CDM625A