Odu | Config (Kst-2000A/B) - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
CDM-625A ODU (Transceiver, BUC, LNB) Operation

10.4.2.4.2.2 ODU | Config (KST-2000A/B)

Figure 10-10 shows the 'ODU | Config' page as it appears when you configure the Comtech EF
Data KST-2000A/B as the ODU. Use this page to configure the primary ODU's Transmit and
Receive Parameters.
Up Converter
• Frequency – Enter a value in MHz.
• Attenuation – Enter a value in dB.
•
Output – From the drop-down list, select On or Off.
Down Converter
•
Frequency – Enter a value in MHz.
•
Attenuation – Enter a value in dB.
•
Rx Band (For KST-2000B Only) – From the drop-down list, select band A (10950 to 11700
MHz), band B (11700 to 12200 MHz), or band C (12250 to 12750 MHz).
HPA
• HPA Power Enable – From the drop-down list, select On or Off.
•
HPA Fault Logic – From the drop-down list, select Summary or No Summary.
Figure 10-10. ODU | Config page (KST-2000A/B)
10–47
Revision 0
MN-CDM625A