IBM PowerPC 405GP User Manual page 403

FBB AS PS SC MA
1
15
* * * * *
101 91 Sl 71 61 51 41 31 211 I
0
I
t t t t t
SE PER MWI ME IDA
Figure 17-27. PCI Command Register (PCICO_CMD)
15:10 Reserved
9 FBB Fast Back-to-Back Write Enable Enables PCI masters to perform fast back-
to-back transactions. Because he PCI
bridge does not perform fast back-to-back
transactions; FBB is read-only and returns
o
when read.
S
SE PCISErr Enable Enables driving PCISErr when a PCI bus
o
Disabled parity error is detected when the PCI
1 Enabled
bridge is the PCI target. PCICO_CMD[PER]
must be enabled for address parity errors.
PCICO_CMD[PER] and
PCICO_ERREN[WDPE] must be enabled
for write data parity errors.
7 AS Address stepping wait states. The PCI bridge does not address step
(except for address stepping when
generating a Config Type 0 cycle); AS is
read-only and returns 0 when read.
6 PER Parity error response This bit is enabled for all types of PCI bus
o
Disabled parity errors, including the following:
1 Enabled
• PCI data bus parity errors while PCI is
master.
• PCI data bus parity errors while PCI is
target.
• PCI address bus parity errors.
When parity error response is disabled,
detection of these errors is masked and
PCIPErr (PERR#) is not asserted, although
parity is still generated.
5 PS
Palette Snooping Enable special palette snooping.
The PCI bridge is not a VGA device; PS is
read-only and returns 0 when read
4 MWI
Memory Write and Invalidate Enable
The PCI bridge does not generate this
command; MWI is read-only and returns 0
when read.
3 SC Special Cycle Operations Enable The PCI bridge never monitors special
cycles; SC is read-only and returns 0 when
read.
17-32 PPC405GP User's Manual Preliminary