Software Configuration; Replacing An M.2 Ssd On Pdual Ap200; Preliminary Steps - Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual

Expansion cards and backup units
9.5.4.4

Software configuration

The M.2 SSDs are intended to be used as boot device in a RAID 1 array.
Ê Install a RAID 1 array, see description CP400i included in "Modular RAID
Controllers" user guide.
Ê Install the desired operating system, see the corresponding installation
manual of the operating system.
9.5.5

Replacing an M.2 SSD on PDUAL AP200

Upgrade and Repair Unit
(URU)
Tools: Phillips PH0 / (+) No. 0 screw driver
Note on viewing M.2 SSD in ServerView RAID Manger
The M.2 SSDs are listed under the PSAS CP400i.
Figure 155: Example M.2 SSD in ServerView RAID Manager
1 M.2 SSD in slot 0
2 M.2 SSD in slot 1
9.5.5.1

Preliminary steps

"Locating the defective server" on page 47
Ê
"Shutting down the server" on page 49
Ê
"Disconnecting the power cord" on page 50
Ê
"Getting access to the component" on page 52
Ê
240 Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 10 minutes
RX2530 M4