Address Group Summary Screen - ZyXEL Communications UAG4100 User Manual

The following table describes the labels in this screen.
Table 154 IPv4 Address Configuration > Add/Edit
LABEL
Name
Address Type
IP Address
Starting IP
Address
Ending IP
Address
Network
Netmask
Interface
OK
Cancel

33.3 Address Group Summary Screen

The Address Group screen provides a summary of all address groups. To access this screen, click
Configuration > Object > Address > Address Group. Click a column's heading cell to sort the
table entries by that column's criteria. Click the heading cell again to reverse the sort order.
Figure 216 Configuration > Object > Address > Address Group
Chapter 33 Addresses
DESCRIPTION
Type the name used to refer to the address. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value is
_
case-sensitive.
Select the type of address you want to create. Choices are: HOST, RANGE, SUBNET,
INTERFACE IP, INTERFACE SUBNET, and INTERFACE GATEWAY.
Note: The UAG automatically updates address objects that are based on an interface's IP
address, subnet, or gateway if the interface's IP address settings change. For
example, if you change lan1's IP address, the UAG automatically updates the
corresponding interface-based, LAN subnet address object.
This field is only available if the Address Type is HOST. This field cannot be blank. Enter
the IP address that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter
the beginning of the range of IP addresses that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter
the end of the range of IP address that this address object represents.
This field is only available if the Address Type is SUBNET, in which case this field cannot
be blank. Enter the IP address of the network that this address object represents.
This field is only available if the Address Type is SUBNET, in which case this field cannot
be blank. Enter the subnet mask of the network that this address object represents. Use
dotted decimal format.
If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE GATEWAY as the
Address Type, use this field to select the interface of the network that this address object
represents.
Click OK to save your changes back to the UAG.
Click Cancel to exit this screen without saving your changes.
UAG4100 User's Guide
323