Address Group Summary Screen; Figure 418 Object > Address > Address Group; Table 201 Object > Address > Address > Edit - ZyXEL Communications ZyWALL USG 300 User Manual

The following table describes the labels in this screen.
Table 201 Object > Address > Address > Edit
LABEL
Name
Address Type
IP Address
Starting IP
Address
Ending IP
Address
Network
Netmask
Interface
OK
Cancel

37.3 Address Group Summary Screen

The Address Group screen provides a summary of all address groups. To access this screen,
click Object > Address > Address Group. Click a column's heading cell to sort the table
entries by that column's criteria. Click the heading cell again to reverse the sort order.
Figure 418 Object > Address > Address Group
ZyWALL USG 300 User's Guide
DESCRIPTION
Type the name used to refer to the address. You may use 1-31 alphanumeric
characters, underscores( ), or dashes (-), but the first character cannot be a
_
number. This value is case-sensitive.
Select the type of address you want to create. Choices are: HOST, RANGE,
SUBNET, INTERFACE IP, INTERFACE SUBNET, and INTERFACE GATEWAY.
Note: The ZyWALL automatically updates address objects that are
based on an interface's IP address, subnet, or gateway if the
interface's IP address settings change. For example, if you
change ge1's IP address, the ZyWALL automatically updates
the corresponding interface-based, LAN subnet address
object.
This field is only available if the Address Type is HOST. This field cannot be blank.
Enter the IP address that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be
blank. Enter the beginning of the range of IP addresses that this address object
represents.
This field is only available if the Address Type is RANGE. This field cannot be
blank. Enter the end of the range of IP address that this address object represents.
This field is only available if the Address Type is SUBNET, in which case this field
cannot be blank. Enter the IP address of the network that this address object
represents.
This field is only available if the Address Type is SUBNET, in which case this field
cannot be blank. Enter the subnet mask of the network that this address object
represents. Use dotted decimal format.
If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE
GATEWAY as the Address Type, use this field to select the interface of the
network that this address object represents.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving your changes.
Chapter 37 Addresses
591