Clear Port Mirroring; Set Mirror Vlan - Enterasys SECURESTACK C3 Configuration Manual

clear port mirroring

Example
This example shows how to create and enable port mirroring with ge.1.4 as the source port, and
ge.1.11 as the target port:
C3(su)->set port mirroring create
clear port mirroring
Use this command to clear a port mirroring relationship.
Syntax
clear port mirroring source destination
Parameters
source
destination
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear a port mirroring relationship between source port ge.1.4 and
target port ge.1.11:
C3(su)->clear port mirroring

set mirror vlan

Assigns a VLAN to be reserved for mirroring traffic. If a mirrored VLAN is created, all mirrored
traffic will egress VLAN tagged. All traffic on the mirror VLAN will be flooded.
Syntax
set mirror vlan vlan-id
Parameters
vlan‐id
Defaults
None.
7-40 Port Configuration
ge.
1.4
Specifies the source port of the mirroring configuration to be cleared. For
a detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 7‐1.
Specifies the target port of the mirroring configuration to be cleared.
ge. ge.
1.4 1.11
Specifies the VLAN to be used for remote port mirroring. The ID can
range from 2 to 4093.
ge.
1.11