Clear Port Mirroring - Enterasys SecureStack C2 C2G170-24 Configuration Manual

clear port mirroring

Parameters
create | disable |
enable
source
destination
Defaults
None.
Mode
Switch command, read‐write.
Usage
Note that LAG ports and their underlying physical ports, as described in "Link Aggregation
Control Protocol (LACP)" on page 7‐38, cannot be mirrored.
Example
This example shows how to create and enable port mirroring with ge.1.4 as the source port, and
ge.1.11 as the target port:
C2(su)->set port mirroring create
C2(su)->set port mirroring enable
clear port mirroring
Use this command to clear a port mirroring relationship.
Syntax
clear port mirroring source destination
Parameters
source
destination
Defaults
None.
Mode
Switch command, read‐write.
7-36 Port Configuration
Creates, disables or enables mirroring settings on the specified ports.
Specifies the source port designation. This is the port on which the traffic
will be monitored. For a detailed description of possible port‐string values,
refer to "Port String Syntax Used in the CLI" on page 7‐2.
Specifies the target port designation. This is the port that will duplicate or
"mirror" all the traffic on the monitored port. Only one destination port
can be configured per stack, if applicable.
For a detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 7‐2.
ge.
1.4
ge.
1.4
Specifies the source port of the mirroring configuration to be cleared. For
a detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 7‐2.
Specifies the target port of the mirroring configuration to be cleared.
ge.
1.11
ge.
1.11