Table of Contents
Advertisement
Setting Speed and Duplex Mode
Parameters
port‐string
name
Defaults
If name is not specified, the alias assigned to the port will be cleared.
Mode
Switch command, read‐write.
Examples
This example shows how to assign the alias "Admin" to
B3(rw)->set port alias ge.3.3 Admin
This example shows how to clear the alias for
B3(rw)->set port alias ge.3.3
Setting Speed and Duplex Mode
Purpose
To review and set the operational speed in Mbps and the default duplex mode: Half, for half
duplex, or Full, for full duplex for one or more ports.
Commands
For information about...
show port speed
set port speed
show port duplex
set port duplex
show port speed
Use this command to display the default speed setting on one or more ports.
5-8 Port Configuration
Specifies the port to which an alias will be assigned. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 5‐1.
(Optional) Assigns an alias name to the port. If the alias name contains
spaces, the text string must be surrounded by double quotes. Maximum
length is 60 characters.
Note: These settings only take effect on ports that have auto-negotiation disabled.
.3.3:
ge
.3.3:
ge
Refer to page...
5-8
5-9
5-10
5-13
Advertisement
Table of Contents
