AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 700

Integrated Administration
Set Up
You cannot program the common information until you have completed basic
setup programming for the communications system. Use SPM or the system
programming console to program the following:
Mode of operation
System numbering
System operator positions
Phantom extensions
Lines/Trunks to pools assignment
NOTE:
If you do not want all lines to have the same application services, you must
assign lines with the same services to the same pools
Programmable Options
When you complete the system setup, you can use the information in Table 4–6
to program through Integrated Administration.
Table 4–6. Programming through Integrated Administration
Option
Automated Attendant Calling Group
Call Answer Calling Group
FAX Response Calling Group
Information Service Calling Group
Message Drop Calling Group
Voice Mail Calling Group
Coverage Group
Reliable Disconnect
Delay Ring
Coverage Delay Ring
VMS Transfer Return Interval
Transfer Return Time
The information programmed through Integrated Administration is shared with
the communications system control unit. The information does not have to be
programmed again when you program the communications system.
4–328
Programming Procedures
Factory Setting Range
770
7926
7924
7927
7928
7925
30 1 to 30
yes
2 rings 1 to 6 rings
3 rings 1 to 9 rings
6 rings 0 to 9 rings
6 rings 0 to 9 rings