AT&T MERLIN LEGEND Release 3.1 System Programming Manual page 389

System Renumbering
Console Display/Instructions
6 Return to the System Programming menu.
Exit Exit
Select two times.
Single Renumbering
Use this procedure to assign a specified extension number to a telephone,
accessory, line, pool (Hybrid/PBX only), calling group, paging group, or Listed
Directory Number. Single renumbering is also used for Remote Access, Park,
Idle Line Access (Key and Behind Switch only), and Automatic Route Selection
(Hybrid/PBX only).
See Chapter 3, "Common Administrative Procedures" for detailed information.
!
CAUTION:
Select
If you press Home , extensions may remain in the forced idle condition
(indicated when the LED next to each DSS button is on). To restore
extensions to their normal operating state, restart the system.
When required, this procedure should be performed immediately following the
selection of a system numbering plan.
Summary: Single Renumbering
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Exit
on the console or
System manager
All
System idle
Form 2a, System Numbering: Extension Jacks
Form 2b, System Numbering: Digital Adjuncts
Form 2d, System Numbering: Special Renumbers
Not applicable
Old and new extension numbers
Yes
No
SysRenumber
Enter
Dial new ext. no.
Select item
new ext. no.
Additional Information
on the PC after renumbering extensions.
Single
Select item
Enter Exit
Type old ext. no.
Programming Procedures
PC
Dial old ext. no.
Exit
Type
4–17